Ziplevel ZLP-100 Use and Care Manual download pdf (Page 36)

1) Secure the Base Unit after removing the Measurement Module.

2) Extend the Unipod from the top down and retract from the bottom up (see

page 14). Always gently tighten bushings (avoid over-tightening).

3) Hold the Measurement Module in the handgrip areas to the right and be-

neath the keypad. For single handed operation, use the thumb to press

the most frequently used buttons: ON/OFF, HOLD and ZERO. The left

hand can manipulate the Cord. Release or hold steady while reading (see

page 8).

4) In muddy conditions use a rag to wipe down the Cord before reeling in.

This can also remove Cord twists.

5) Place Module on ground beside Base Unit then pick up Base Unit and reel

Cord through Cord entry area by holding the Base Unit handle with Base

Unit tilted backward at about 45° (for example, resting against thigh). This

will ease reeling, reduce wear and keep docking area clean (see page 8).

6) Use a coin, screwdriver or thumbnail to loosen battery door screw to re-

place 9V alkaline battery. Lift the terminal end of battery with thumbnail

or simply thump Measurement Module against your hand and catch the

battery. Note: The protective Boot is more easily removed when warmed.

31 ▪ USE TIPS

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43 44

No comments

Ziplevel ZLP-100 Use and Care Manual Page 36